LAB 3-4  

Friday, November 14, 2008
















starting out with lab 3-4 in ospf ... its simple and similar to eigrp frame-relay lab ..not thing there much ..... i have seen is-is and left it for last ... i went after bgp and started the cbtt nuggets .. it will take three more days time to complete the bgp i guess from the video tutors

*is-is labbing will be done at the end of the course

any how here is the 3-4 ospf lab

Lab 3-4a OSPF over Frame Relay

Learning Objectives

• Configure OSPF over Frame Relay
• Use non-broadcast and point-to-multipoint OSPF network types
• Modify default OSPF timers

SCENARIO



You are responsible for configuring the new network to connect your company’seast branch and west branch through the company headquarters represented by loopback interfaces on each of the three routers. The physical devices havejust been installed and connected over Frame Relay hub-and-spoke. Configure OSPF to allow full connectivity between all departments.There will also be an Ethernet connection between East and West. This
represents a backup line given by a service provider.This topology may appear again in future labs, so save your configuration when you are done.


I WOULD JUST POST THE RUNNING CONFIGS AS THERE IS NOTHING HERE I COULD DOCUMENT AS THE PREVIOUS LAB ..EVERYTHING IS OF FRAME-RELAY WHICH IS DONE IN EIGRP SAME MAPPINGS OF IP AND DLCIS ROUTES ..SO NOTHING MORE SPECIFIC

POINT TO REMEMBER IS THAT

BROADCAST HAS A DR AND CARE SHOULD BE TAKEN THAT NO BDR GETS ELECETED SUING IP OSPF PRIOPRITY 0 COMMAND

POINT - POINT DOSENT NEED ANY DR OR BDR IT WONT ELECT AND DONT NEED ANY NEIG STATEMENTS TO CONFIURE .

Design by Blogger Buster | Distributed by Blogging Tips